As the saying goes:an antidote against the disease;indeed,if can not find the cause,how can there be a solution to solve it?The same is true for mechanical equipment,only to find out where is the problem,then there can have reasonable solutions.Belt weigher is mainly used for measuring equipment,and belt conveyor is used to match with belt weigher,which also can be referred to as "belt";then under what circumstances belt weigher will appear the materials spreading problem?How to solve it?

Firstly: Reprint point will appear materials spreading problem:Reprinted point is prone to appear the materials spread to the belt weigher hopper,guiding groove,etc,this is a very dangerous situation,and need careful operation.The above situation can be mastered on delivery,be dealt with on enjoying enhanced protection.

Secondly: Materials spreading problem will appear when concave belt hanging:the concave belt when the radius of curvature smaller belt will attack when vacant,this time belt trough status changes,due to the belt has come to the grooved roller group,individual trough angle becomes small,so that the local materials sprinkled into it.Thus,in the design stage of belt scale,it can take a larger radius of curvature of the concave section to prevent the onset of such conditions.

Thirdly: Materials spreading problem will appear when belt scale deviates:This is an often encounter problem,due to the two edge height of the belt change at run time,one side is high,while the other side is low,the materials spread out from the low side.The processing method is to adjust the deviation of belt scale.