Several Solutions To Solve The Deviation Of Belt Weigh Scale

author：admin    Released：2013-12-20 16:13:45

The deviation of belt weigh scale is the phenomenon that tape centerline deviates transport aircraft centerline during in no-load operation or in the process of weighing,and it is also the phenomenon that can not be completely avoided for belt weigh scale.Once the deviation occurs,belt weigh scale would not measure materials normally precise,in severe cases,belt weigh scale even will not run properly.Thus the loss is great to users,when faced with such a situation,the staff need to check carefully,find the problem,so it is sure to slove the deviation problem of belt weigh scale,then the equipment can operate normally.

1、When installing the center line is not straight,there will be occured deviation,so it should keep the centerline vertical;

2、If the cutting point of the materials is not in the middle of the belt,there will be occured deviation once a load put on the belt.This situation should be adjusted accordingly;

3、The roller of belt weigh scale is not in levels also will cause the deviation,if the installation was not paying attention to,leading not on levels,it should be in levels immediately;if it is due to the manufacturing process itself is not flat,which would need to be reworked cylindrical drum;

4、Belt weigh scale care rolls with tape centerline axis vertical when installed will often cause the deviation.The belt deviate to where,it will move in the direction of roller belt look;

5、The surface of the roller of belt weigh scale bond materials,the tape will deviate to one side.This is caused by the scattering materials,it should be taken to prevent this phenomenon and often clean it.

Finally,thank you so much to visit our official website,and welcome to our company to visit whoever is interested in belt weigh scale,we will give you a satisfactory service.